Take an agency managing 200 homes with 30 repairs a month. If half of them are above the landlord’s limit, and each of those takes three calls or emails of ten minutes to get an answer, that is seven and a half hours a month spent asking “can we go ahead?”. These are assumptions, not measured figures, so count your own for a month. Then add the hours spent chasing contractors for invoices, and answering landlords who ring to ask what a cost on their statement was for.
The repair itself is the contractor’s work. The loop around it is yours, and it is where the time goes. This guide sets out that loop from start to finish: the limit, the approval, the emergency, the invoice and the statement.
The repair limit, written into the terms
The repair limit, sometimes called the authorisation limit, is the most you may spend on one job without asking the landlord. It belongs in the terms of business, agreed with each landlord, because it is their money and their legal duty. Section 11 of the Landlord and Tenant Act 1985 puts the repairing duty on the landlord, whoever manages the home (legislation.gov.uk).
Write four things down:
- 1The figure, per job, and whether it includes VAT.
- 2What counts as an emergency, and that emergency work goes ahead within the terms, with the landlord told straight after.
- 3When you get more than one quote, if the landlord wants that above a set figure.
- 4How the cost is paid: from the rent you hold, and shown on the next statement with the invoice.
If your agency adds a fee to contractor work or receives anything from the contractor, say so in the terms. An agency in England must publish its fees, each with tax included (Consumer Rights Act 2015, section 83), and a landlord who finds an undisclosed charge on an invoice rarely stays.
A limit that suits one landlord does not suit another. A landlord with one flat and a tight budget may want every job above a modest figure asked; a portfolio landlord may want you to get on with anything short of a new boiler. Set it with each one, and look at it again at renewal. The full set of terms is in letting agent terms of business.
Asking the landlord, in one message
Most approval calls take three contacts because the first message is missing something. An approval request that gets an answer first time carries:
- What is wrong, in the tenant’s words, with their photos.
- What the contractor proposes, and the quote, with VAT shown.
- Why it is needed now, or what happens if it waits.
- Your recommendation, in one sentence.
- A way to answer in one tap: approve, decline, or ask for a call.
- When you need the answer, and what you will do if none comes.
The kitchen tap at 4 Elm Road is leaking under the sink; photos attached. Our plumber quotes £145 including VAT to replace the tap. Left, it will damage the cupboard base. We recommend going ahead this week. Please approve, decline or ask us to call by Thursday.
Ask only once the quote is in. A request without a figure brings a call asking for one.
Emergencies do not wait
A gas leak, no heating or hot water in cold weather, a burst pipe or a home that cannot be locked goes ahead within the terms, and the landlord hears about it straight after. Waiting for an answer while the heating is off in January puts the landlord in breach of their duty, and you in the middle of the complaint.
Social landlords in England must deal with an emergency hazard within 24 hours under Awaab’s Law (Hazards in Social Housing Regulations 2025, regulation 5). It does not bind private landlords or their agents, but 24 hours is a fair benchmark to work to. Whatever you do in an emergency, write down why you went ahead, before the invoice arrives. Emergency repairs out of hours covers the first hour.
The contractor’s invoice
The invoice is where the money is, and where the loop most often stalls.
- One invoice per job, matching the quote, or with the difference explained.
- The VAT number, if VAT is charged.
- A photo of the finished work with it.
- Checked before you pay: against the quote, against what the landlord approved, and against the landlord’s balance. A payment larger than the balance you hold for that landlord is paid with other clients’ money.
- On the next statement, as its own line with the invoice attached, so the landlord does not have to ask.
Repair costs are an allowable expense for the landlord against the rent; improvements are not (GOV.UK). A clear description on the invoice (replaced the tap, not upgraded the kitchen) saves the landlord’s accountant a question, and saves you the call that follows it.
Closing the loop with the landlord
A repair is finished for the landlord when they know it is done, what it cost and why. Send a short note when the job is complete: what was wrong, who attended and when, the cost and the invoice. The landlord who hears about a repair before it appears on their statement does not ring about the statement.
| Step | Who does it | What is kept |
|---|---|---|
| Tenant reports, with photos | The tenant | The report, dated |
| Priority set, contractor sent | Your property manager | The priority and the response date |
| Quote received | The contractor | The quote |
| Above the limit: landlord asked | Your property manager | The request and the answer |
| Work done | The contractor | Photos and the completion date |
| Invoice checked and paid | Your accounts | The invoice, the payment |
| Landlord told | Your property manager | The note sent |
| On the statement | Your accounts | The line, with the invoice |
Each row has a name and a record. When a landlord questions a cost six months later, the answer is in the file, not in someone’s memory.
Where the loop leaks time
- No limit on file. Every job becomes a phone call. Agree a figure with every landlord at onboarding.
- Asking before the quote. The landlord asks “how much?” and the loop starts again.
- Approvals in someone’s inbox. A colleague cannot see that the landlord said yes. Keep the answer on the repair.
- Invoices by email to whoever booked the job. They arrive late, or twice. Ask contractors to send them one way, every time.
- Costs that surprise the landlord. A line on the statement with no note before it brings a call. Tell them when the job is done.
The repair loop in one place. In a LetCompliance agency workspace, you set each landlord client’s Repair limit on their page. Above it, Ask the landlord emails them from your agency with the quote and a link, valid for 14 days, showing the tenant’s description and photos, where they approve, decline or ask for a call. The answer is kept on the repair, on the client’s page under Approvals and in the notifications of whoever asked. Going ahead without approval needs a written reason, kept on the repair and in the audit log, and an urgent safety repair shows a warning that the landlord’s duty does not wait. The contractor quotes and updates the job from a link with no login, and sends the final amount and the invoice from it as one draft cost you confirm before it reaches a statement. Send to landlord on a completed repair tells them what was done, when, by whom and at what cost, with the invoices. Your agency pays contractors from its own bank, as now. Agency plans start at £24 a month. Every agency plan has every agency tool and unlimited seats and branches; only the number of properties and the storage differ.